Laniako 3DCreations
Ready to buy · On Etsy

Pegboard Holder for a Handheld Vacuum

A pegboard holder for a handheld vacuum with a round body of about 55 mm. We have printed it and fitted it on our own pegboard with the vacuum it was designed around. It is now for sale on Etsy for US$25, shipping to the US and UK.

Photo of the printed red holder on a black pegboard, holding a white handheld vacuum upright with its charging cable plugged in underneath.
Photo of the printed holder on our pegboard, with the vacuum it was designed around.
Render of the holder at an angle: a round cup with a slot cut in the front, on a braced back plate with four pegboard pins.
Render of the CAD model, not a photo of a printed part. Angled view: cup, front finger slot and braced back plate.

About this design

The vacuum sits nozzle-up in a cup. You drop the body in and lift it straight out from above. A 24 mm slot at the front of the cup leaves room for your fingers, and a 20 mm hole in the base lets dust fall out and air through. That hole is not designed to line up with any vacuum’s vents or charging port.

We designed it around a Xiaomi handheld vacuum we own. Other handheld vacuums with a round body of about 55 mm may also fit, but we haven’t checked any of them. Before you order, measure your vacuum’s body diameter at the height where it would sit in the cup.

Front view render of the holder showing the finger slot running down the front of the cup.
Render of the CAD model: front view with the 24 mm finger slot.
Top view render looking down into the cup, showing the round opening and the hole in the base.
Render of the CAD model: top view into the cup and the 20 mm base hole.

How it mounts

The holder is made for pegboard with a 17 mm hole pitch (horizontal and vertical) and a 3 mm board. It needs more than 15 mm of clear space behind the board. It is held on by four separate locking pins, which go through slotted holes in the back plate. The slots are 51 mm apart horizontally and 17 mm apart vertically.

If your pegboard has a different pitch or thickness, this version won’t fit as drawn. Tell us your board’s measurements anyway, because it helps us decide which variants are worth making.

What happens next

  1. Test print and fit. Done: the printed holder is on our pegboard, holding the vacuum it was designed around (photo above).
  2. Listing. Done: it is on Etsy, shipping to the United States and the United Kingdom.
  3. Our own pins. We plan to replace the locking pins with our own design and will re-check the fit with them.

We have not tested how much weight the holder can carry, and we won’t give a load rating until we have.

The locking pins shown follow a common pegboard-pin pattern from a reference file; we plan to replace them with our own design. The holder is not made, endorsed or approved by Xiaomi or any other brand.